How to Open a Video Game Security Case
Download Article
Download Article
From time to time, you may find your DVD case locked. Maybe you checked out a locked DVD from the library, or bought one that wasn't fully unlocked. Whatever the case may be, you can unlock your DVD case with magnets or screwdrivers, depending on the case. Once your DVD is unlocked, you can open it by gripping the middle with each hand and separating the sides with your thumb!
-
1
Align a magnet with the security magnet to the left of the locking bar. A small, internal magnet, located to the left of the locking bar, is keeping the DVD locked. Place one magnet on the left, bottom side of the locking bar. Slide it around a little until you feel the magnets snap into place.[1]
- The locking bar is an indented rectangle located on the edge of your DVD, used to help you open the case.
- Use any household magnet, like from your fridge.
- If your DVD case is clear, you should be able to see the small magnets.
-
2
Align another magnet with the security magnet to the right of the lock. There is another small, internal magnet inside your case, located immediately to the right of the opening along the edge of the case. Place another magnet here.[2]
-
3
Slide both magnets to the right to unlock the internal magnets. With your index finger, slowly move both of your magnets at the same time. Drag the internal magnets, moving the DVD case lock from the "locked" to the "unlocked" position.[3]
- You only have to move the magnets about 1 inch (2.5 cm) to the right.
- If your magnets do not unlock the case, try this again using stronger magnets.
-
4
Continue sliding until the red icon becomes green. There should be a red security icon in the middle of the locking bar. As you slide the magnets, the icon should move. Continue sliding until the icon is firmly in the green "unlocked" position.
-
5
Hold the DVD case by the locking bar to open the case like a book. Once the DVD case is unlocked, you should be able to easily open the cover. Grip the locking bar from both the front and back of the DVD. Gently pull the cases apart to open your DVD.[4]
-
1
Stick screwdrivers into both lock tabs near the locking bar. There are 2 small holes on the front and back cases about 2–3 inches (5.1–7.6 cm) down from the locking bar. You can access the lock tabs through these small holes. Insert a separate screwdriver into each of these small holes.[5]
- Lock tabs are small, internal locking mechanisms located along the edge of the DVD case.
- Leave both screwdrivers inside the holes at the same time. You need both lock tabs pressed down at the same time to open the DVD.
- If you are having trouble using multiple screwdrivers, ask a friend for help.
-
2
Poke the red lock icon with a third screwdriver. Press another screwdriver against the red locked icon in the middle of the locking bar.
-
3
Slide your middle screwdriver to the right to unlock the security feature. Make sure your lock tabs are both pressed in. With your screwdriver pressed against the plastic, slide the red lock to the right until it becomes the green unlocked icon.[6]
- You should hear a click as the DVD case unlocks.
-
4
Take out all 3 screwdrivers, and open up your DVD case. Once you have moved the lock icon, you no longer need your screwdrivers. Take them out and set them aside. Then, holding the front case with one hand and the back case with another, open the DVD from the locking bar.[7]
Add New Question
-
Question
How do you get a DVD out of a locked case?
Drew Hawkins1
Community Answer
Some DVD cases can be trickier to access than others. Fortunately, you can usually get the DVD out without too much trouble. Use 2 screwdrivers and stick them into both lock tabs near the locking bar. There are 2 small holes on the front and back cases about 2–3 inches (5.1–7.6 cm) down from the locking bar. You can access the lock tabs through these small holes. Then, take another screwdriver and poke the red lock icon in the middle of the locking bar. With your screwdriver pressed against the plastic, slide the red lock to the right until it becomes the green unlocked icon. Once you have moved the lock icon, you no longer need your screwdrivers. Take them out and set them aside. Then, holding the front case with one hand and the back case with another, open the DVD from the locking bar.
-
Question
How do you get the red locking cap off a DVD case?
Drew Hawkins1
Community Answer
You can try using magnets to get the job done. A small, internal magnet, located to the left of the locking bar, is keeping the DVD locked. So to open up the case, you can place one magnet on the left, bottom side of the locking bar. Slide it around a little until you feel the magnets snap into place. There's another magnet inside the case located to the right of the opening along the edge of the case. Align another magnet here and with your index finger, slowly move both of your magnets at the same time. Drag the internal magnets, moving the DVD case lock from the "locked" to the "unlocked" position.
-
Question
How do you open a display case at Walmart?
Drew Hawkins1
Community Answer
The display cases at stores like Walmart and Target are designed to be difficult to open as a security measure. You really shouldn't try to open one or you could get in trouble and face a serious fine. You could even have the incident go on your criminal history. If you need to access one of the display cases, ask a store employee to help you. They'll be able to use the proper key that unlocks the case so you can safely and legally access it. If you can't locate an employee, head to a register and ask them if they can contact someone to assist you.
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Thanks for submitting a tip for review!
About This Article
Thanks to all authors for creating a page that has been read 40,420 times.
Is this article up to date?
How to Open a Video Game Security Case
Source: https://www.wikihow.com/Open-a-DVD-Case